Jiangsu hantong auto parts co., LTD. : how to replace the front bumper
PubTime:2018-12-10
1 first put the front bumper under the seat of the screw removed and then open the front cover, open the front cover can not be anxious to remove the screw, the general vehicle is to remove two headlights screws.
2 in the headlights below there are three screws to the bumper fixed in the keel of the car, and finally the keel above the demolition of a few screws can be safe to remove the bumper.
This is the back of the front fog light. You can see it's a buckle. You can loosen the fog light by rotating the front fog light. Don't unplug the lamp.
4. Loosen the two M10 bolts and the star screws on the hub liner (the specifications are forgotten), leave a gap, and then separate the bar skin from the bracket; As I did below, the three screws were removed, and the bracket, along with the skin, was separated from the fender.
5 plum screwdriver is a deal with the front wheel front lining plate under the 3 screws to take off and then pull out the middle grid mark be careful not to break the clamp in the middle network below the three screws and then the front two sides of the fog lamp intake grille to take off the inside of a screw all removed in the front of the front bar on one side of the front bar to push forward the front bar along the clamp down.
Pay attention to the lights and wiring on the bumper when removing it. When you take the wire out and the light out, it's the bumper.
