Jiangsu hantong auto parts co., LTD. : how to install the pedals
PubTime:2018-12-10
Car footpad stainless steel skid - resistant pedal belongs to the general type, suitable for all kinds of material footpad and all levels of private cars. Its basically action is below the premise that prevents heel slip, lengthen footpad service life as far as possible, so how is car pedal installed?
The car pedal
First of all, the driver sits in the driving position naturally, holding the steering wheel with both feet on the brake and accelerator respectively, and puts the stainless steel anti-skid pedal of the car foot pad in the heel position. If the owner has a large foot, it is necessary to adjust the optimal position of the pedal according to his actual situation.
How to install the pedals?
Then put the pedal in the position of comparison, mark around it with a ballpoint pen, and press down hard, so that the raised bolt will leave a hole in the bottom of the mat, the use of screwdriver and other holes;
Then the car pad stainless steel skid resistant pedal buckle on the pad, screw from the back, so that the steel plate and pad firmly fixed together, its use time is greatly extended.
Finally, it is recommended that the driver conduct a test drive to check whether the size and placement position of the stainless steel anti-skid pedal of the car footpad are appropriate. If there is any discomfort, the driver must adjust it again.
Above is the installation step of car pedal.
